How to Apply: Apply adhesive to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to insure full bedding of the tile. Spread as much adhesive as can be covered with tile in 10 minutes. Back butter large tiles (> 12”x12”) to provide full bedding and firm support. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to imbed tile and adjust level. Check adhesive for complete coverage by periodically removing a tile and inspecting bedding adhesive transfer onto back of tile. If adhesive is skinned over (not sticky), remove and replace with fresh adhesive. Areas of Application For commercial and residential installations of ceramic tile, vitrified tile and natural stone over most drywall boards and clean cement based surfaces. Used where installations must resist physical abuse, shock, and mild chemicals. (Interior & Exterior)   Suitable Substrates

• Concrete
• Cement Mortar Beds
• Plywood
• Gypsum wall board
• Calcium silicate board
• Bison panel board
• Concrete masonry*
• Cement plaster*
• AAC Block masonry*
• Cement terrazzo*
• Cement backer board**
• Existing ceramic tile
• Other resilient tile and stone
• * All cement based surfaces should have been cured as per standard practices and shall be dry for tiling
• **Consult cement backer board manufacturer for specific installation recommendations and to verify acceptability for exterior use.
• Note: Not for use on metal & plastic substrates and metal tiles.