Image Image Image Image Image

SpectraLOCK® 

Pro Premium Grout

LATICRETE® SpectraLOCK® Pro Premium Grout is a patented, high performance grout which offers excellent colour uniformity, durability, stain protection, and beautiful full grout joints in an easy to- use, non-sag formula.

  • Net Weight: 1kg and 5kg. Factory proportioned unit consisting of three conveniently packed components – Hardener, Resin (Part A and Part B) and Coloured Filler Powder (Part C).

     

  • NOTE:
    1. Quantities shown are approximate and are given for estimating purposes only. Actual job site coverages may vary.
    2. It is always good practice when calculating coverage to allow for 10-15% additional material for wastage and spillage.

  • Available in 20 attractive colours

    • ANSI: A 118.3
    • EN 13888: RG2
  • • Easy to Install & Clean
    • Full Flush Joints
    • Doesn’t retain dirt & dust
    • Maximum Non sag performance

  • Surface Preparation

    Before starting to grout, remove debris in grout joints and lightly sponge (wet) the tile surface to remove dust and dirt. Do not clean tiles with acid cleaners. Substrate temperature must between 60°F (16°C) and 90°F (32°C).

    Mixing

     Empty entire contents of SpectraLOCK® Pro Premium Grout Part “A” and Part “B” pouches into a clean mixing pail. Mix with a margin trowel or a slow speed drill mixer until liquids are completely blended. Add at least ¾ of SpectraLOCK® Pro Premium Grout Part “C” Filler Powder and mix to a uniform consistency. Add remaining powder as per mix consistency requirements. Mix as stiff as possible to work into the joints.

    Application

     Immediately pour entire contents of bucket onto working area. Use a plastic sheet as a drop cloth. Use standard epoxy grouting techniques to work with SpectraLOCK® Pro Premium Grout into tile joints. SpectraLOCK® Pro Premium Grout can also be applied with a caulking gun. Be sure all grout joints are packed full. Remove as much excess material as possible with grout float before initial cleaning. Do not leave excess grout on the face of tiles. 

    Cleaning

    Remove excess grout from the face of the tiles with the edge of the grout float. Hold the float at a 900 angle and pull it diagonally across the joints and tile to avoid pulling out the material.

    Initial Cleaning: After 30-45 min of the application of the grout, lightly run the wet sponge on the surface of the tile & joint with sponge provided to remove any excess grout. Then take a clean thick white towel / sponge and drag across the tile to remove any residue.

    Final Cleaning: Within 24 hours, do a second cleaning with normal detergent soap and sponge to remove any haze from the tile.

  • INTERNAL AND EXTERNAL FLOOR & WALL**
    • Residential & Institutional kitchens
    • Cafeterias & Food joints
    • Wash rooms & Clean rooms
    • Swimming pools, Spa & Sauna
    • Hospitals, Operation theatres, Laboratories
    • Schools & Education Institutes
    • Podium slabs, drive ways & Atriums
    • Terraces & Balconies*