Image Image Image Image Image
  • LATICRETE® 600

  • LATICRETE® 600 SERIES UNSANDED GROUT
    A carefully prepared blend of Portland cement, graded aggregates, fortifiers and colour-fast pigments, it is designed for joint width 1mm to 3mm, for porous & absorbent type tiles, non-vitreous clay tiles, and marble & glazed wall tiles. Suitable for internal and external applications

     

    • 500g, 1 kg and 10 kg

    • Approximate sq.ft. coverage per 10Kg bag of LATICRETE® unsanded Grout-600 series.

       

       

       

       

       

       

      Glass Mosaic – 125 Sq.ft. to 130 Sq.ft. per 10kg

      NOTE:
      1. Quantities shown are approximate and are given for estimating purposes only. Actual job site coverages may vary.
      2. It is always good practice when calculating coverage to allow for 10-15% additional material for wastage and spillage.

    • Available in a range of more than 36 colours

      • ANSI: A 118.6
      • EN 13888: CG1
    • • For tile joints 1 – 3mm
      • Uniform color
      • Hard and durable
      • Economical

       

    • When the tiles/ stones have set firm, spacers and bottom support can be removed.

      Cement based colour Grout

      Use LATICRETE® 600 series / Aquashield Grout (available in a range of colours) when grout joints are less than 3 mm wide and LATICRETE® 500 series Sanded Grout Filler (available in a range of colours) for joints 3mm – 12mm.

      The Cement based colour joints are strong and are resistant to weather, cracking and discolouration.

      Mixing Ratio:

      LATICRETE® 600 series Unsanded Grout/ Aquashield : LATICRETE® 1776

      10kg bag         : 3.75 ltr

      LATICRETE®  500 Series Sanded Grout : LATICRETE® 1776

      10 kg bag             : 1.75 ltr

      Mix the grout filler with LATICRETE® 1776 Latex Admix, mix only enough that can be used in 30 min or less. Clean up immediately before beginning next mix.

      When applying, the grout joints should be free of dirt, debris or tile spacers.  Sponge or wipe dust/dirt of tile faces and remove water standing in joints.  Pack joints full and free of voids with rubber grouting float.  Remove excess grout from tile faces using edge of rubber float and diagonal strokes (at 45° angle to direction of joints). When the joints have set, use a moist sponge to remove excess grout from the tile and joint. Use minimal water for clean up. Final clean up to remove any grout haze should be carried out within the next 12 – 24 hours.

    • Residential, commercial, external facades.